FlowTech™ Hotend for Creality Ender 3 V3 SE

This hot end made my ender 3 v3 se a machine! Seriously faster heat up and beautiful extrusion, I have only printed pla until now I know the machine can do petg but I felt better trying it with this hotend and it prints petg and pla beautifully totally worth it get the heatsink to go with it as well you won't be disappointed installation was buttery smooth and easy!

I was having problems with thermal runaways but the screen was showing normal temperature, under extrusion issues etc, I was sceptical about ordering it after reading some reviews but man am I glad I purchased it wow!!!! Print quality is insanely good compared to original and no more under extrusion issues, clear colour instructions everything screwed together perfectly absolutely amazing love it!! Thankyou guys

I got the full kit hotend alone with some more nozzles and there heat sink. The only two things I have found is that after doing the upgrades is one you need a PFTE tube to run from the extruder and the heat sink due the fact there is small gap between the heat sick and the bottom of the extruder. That and for some reason 2 of the fan screws would not get down to hock up with the heat sink. But two of them work just fine. The only thing I have found after the full upgrade and doing a auto PID on it that the hotr end does get up to heat lot faster then the old on but I found that I have to run my print time far less temp them I would with the stock because it gets the filament so warm that it starts to cock it to the point that it starts breaking down and popping even thought there now water in the filament that I'm using. BUt other then I would say get one you will see night and day dif just your first time out, you may need to do some moding to your parts cooling if your not running the stock tool head cover.

I purchased my Microswiss Flowtech SE version on a splurge spree for parts to upgrade the printer along with the Microswiss Heatsink for the SE. I found the install extremely easy. After running the first flow test I was amazed to be able to get close to 28mm/s3 on the new setup with Regular PLA. I have not experienced any clogs or jams while using it. Prints have very consistent extrusion and layer adhesion. When attending the RMRRF I picked up a few of the CM2 nozzles and another Flowtech kit for my older K1 MAX and installed a .6mm CM2 nozzle on that one. Was very pleased with the increased flow rate on that as well. After printing with the Flowtech on both machines now for almost 3 months I can honestly say. I NEED 7 more, I like them that much. 2 for K1's, 1 for Neptune 4, 1 for Neptune 4 Plus, 1 for CR10se, 1 for V3 (xz) and 1 for my V3 Plus. I just ordered the K1's kit yesterday. Would HIGHLY recommend these over the stock setup.

Althou getting this work was little bit hassel cause i didn't seem to get copper thingi pushed as up as it should go. I finaly got this to work and printing quality is super nice. Less stringin, very smooth surface. After little bit rocky start i'm very pleased whit the product. Customer support was also fast and helpful.